Microcontroller PCB for Attitude System (Thesis) - II

The PCB that I intend to use as a prototype interface board arrived from iTeadStudio today. The quality is quite good, and for only $9.99 + shipping, this service is what I will be using from now on (except for very high tollerance stuff).

Half of the boards have been electricly tested, and are marked in red on one side.

There are a few minor issues, all of which I can live with. The main issue is that the silkscreen was converted to the same font. This caused som silkcreen to get into a few vias, and at one place it was almost completely gone. As long as I'm aware of this in the future, it's not going to be a problem.

Here is the front side of the PCB




And here is the back